|
Notching an AK-47 Safety Selector Lever for Bolt Hold-OpenMake Final Changes AK-47 Safety Lever - Rotary Tool & Stone Now is the time to shape the notch to your liking, smooth out ragged edges, and de-burr it so the cut edges of the metal don't tend to cut your fingers. I used a stone wheel in my rotary tool to even out the bottom of the notch and remove the sharp edges. Use a very light touch, and don't remove too much at once. As Dad always says, it's easy to cut some off, but very hard to cut it back on! - Decide Whether or Not to Cut Your AK's Selector (Safety) Lever
- Mark Your Lever
- Gather Your Tools
- Make Initial Cuts and Try it Out
- Finish Cutting the Notch
- Test it Again
- Make Final Changes
- Blue it
- Install and Enjoy!
<< Previous | Next >>
|
|